- •Snowboard methodic guidelines.
- •It is very important to choose the stance you will be riding!
- •1. Equipment check out.
- •2. How to hold, carry, put down and put on the board, safety rules.
- •3. Warm up and get ready for the lecture.
- •4. How to faii down and get up.
- •5. Basic stance, riding stance, exercises on flat area, ride straght down.
- •6. Sideslipping.
- •7. Travers sliding.
- •8. Traverse ride.
- •9. Lifts.
- •10. Drift turn.
- •11. Types of turns
11. Types of turns
Turns can be devided into categories according to various characteristics. Clear terminology is highly important.
according to radius – short, middle, long
according to inside angle – closed, opened
according to realization – drift, carving
Drift and carving turns can be performed in the following forms :
basic (no inveighing neither weighting)
up unweighting
down unweighting
It is easier to control up unweighting turns. Down unweighting turns enables you to
roll the board on edges faster. The pressure on the edge increases.
Up unweighting drift turn (by rising)
Beginners use it the most often.
It starts from traverse ride keeping the basic stance. but you low more. To start to turn,
weight the front foot and rotate your upper body to the turn direction and rise at the same
time. This causes board unweighting. Then weight inner edge by lowing. After you finish
the turn, pose to the basic stance.
Down unweighting drift turn (by lowing )
Useful for long turns at higher speeds. It presents the basic skill for ride on bump slope.
Start the traverse ride by body rotation and forceful upper body down motion (lowing).
The board unweights for a moment so you can roll on to edge.
Then rising gradually, you put more pressure on the edge. This let you make a turn. Finish in the basic stance.
Short drift turn
They link gradually, don’t interpose traversing.
Start the turn by upper body and hips rotation from the basic stance. Rise shortly, roll on
to the opposite edge. Finish the turn with quick lowing. Link the next turn immediately.
Carving turn
It is more dynamic than drift turn. You mostly ride on the edge. This leaves very narrow
track behind.
Start from traverse ride at higher speed. Edge by leaning the body forward to the center
of the turn. Then flex the board and use the flexed edge to turn. Put the weight equally
on both feet. The intensity of pressure depends on the speed. After you complete the turn,
pose in the basic stance – vertically to the board. In this turn, your shoulder always points
in ride direction. You almost don’t rotate the body. Shoulders are parallel to the fall line.
Up unweighting carving turn
Rise and unweight the board. Roll on to edge by leaning the upper body to the center of
the turn. Then low to press the edge more. After completing the turn into traverse ride,
pose to the basic stance.
Down unweighting carving turn
Start the turn by forceful lowing and leaning upper body forward. Before you get to the
fall line, roll the board on to edge by leaning toward the center of the turn. You press the
edge by rising. Weight is put on both legs equally. After completing the turn, pose to the
basic stance.
Short carving turn
Before you get over the fall line, roll the board on to edge by rising and leaning. Upper
body stays relatively still. Shoulders are across the fall line (respect the stance angle).
Then low shortly to complete the turn. Link the next turn immediately.
