Добавил:
Upload Опубликованный материал нарушает ваши авторские права? Сообщите нам.
Вуз: Предмет: Файл:
rules and procedures ATC (5course, state) (1).doc
Скачиваний:
0
Добавлен:
01.07.2025
Размер:
167 Кб
Скачать
☆

3. A) Data link communications initiation procedures.

Before entering an airspace where data link applications are required by the ATS unit, data link communications shall be initiated between the aircraft and the ATS unit in order to register the aircraft and, when necessary, allow the start of a data link application. This shall be initiated by the aircraft, either automatically or by the pilot, or by the ATS unit on address forwarding. The DLIC address associated with an ATS unit shall be published in Aeronautical Information Publications .

Whenever the pilot or the aircraft initiates data link communication procedures, an initiation message shall be sent. Except when the initiation message is corrupted, it shall not be rejected by the ATS unit.

b) Pre-shift preparation of an air traffic controller.

ATCs work in shift pattern. Each controller’s shift is proceeded by pre-shift briefing where meteorologists notify the team about weather conditions for different sectors of control, issue SIGMET, and inform controllers about met conditions at own airport and the nearest airports.

Then military officers take the floor. They remind the team about prohibited areas, advise about restricted areas, state flights, training military flights. For low areas they note explosive work and applications of small-engine aviation. Then a technician reports on technical condition of the operative system, on any changes and malfunctions.

Then the supervisor informs the audience about RW, apron, TW, stand conditions, states if there are any traffic congestions and gives instructions to his team and it is for him to assign controllers to their positions in sectors.

4. A) Essential aerodrome information.

Essential aerodrome information is information about any traffic or facilities at the aerodrome.

This information shall be given to any aircraft. It has to be given in sufficient time for the aircraft to make proper use of it and the hazards shall be identified as distinctly as possible. This information is very important and necessary to safety operations of the aircraft, especially if the aircraft is not familiar with the aerodrome.

Essential information on aerodrome conditions shall include information relating to the following:

a. construction or maintenance on or immediately adjacent to the movement area;

b. rough or broken surface on a RW, a TW, or an apron whether market or not;

c. snow, slush or ice on a RW, a TW, or an apron;

d. water on a RW, a TW, or an apron;

e. snow banks or drifts on a RW, a TW, or an apron;

f. other temporary hazards, including parked aircraft and birds on the ground or in the air;

g. failure or irregular operation of part or all of the aerodrome lighting system;

h. any other pertinent information.

b) General requirements for the controllers.

General requirements for the controllers are:

  • to have appropriate high education and to complete special training programme

  • to possess perfect health (eyesight, hearing, no problems with heart and blood pressure etc.)

  • to have a good command of English (to possess at least the 4th ICAO level)

  • to possess appropriate articulation (clear and distinct speaking)

  • to have spatial awareness

ATC’s activity and responsibility for the lives of people specify certain requirements for candidates’ qualities that have to be met.

Соседние файлы в предмете [НЕСОРТИРОВАННОЕ]