Добавил:
Upload Опубликованный материал нарушает ваши авторские права? Сообщите нам.
Вуз: Предмет: Файл:
Учебник для тех магистр.docx
Скачиваний:
6
Добавлен:
01.07.2025
Размер:
8 Мб
Скачать
☆

3. Experimental

Fig. 1 shows a photograph of the laboratory scale experimental facility used to examine the pyrolysis and gasification of food wastes. Steam is generated from the stoichiometric combustion of hydrogen and oxygen. Steam generated is then introduced into the superheater section to form the gasifying agent at the desired condition. The temperature of the gasifying agent heater is kept at the same temperature as that of the main reactor in which sample material was allowed to undergo gasification. Steam is then introduced into the main reaction chamber that contained the hydrocarbon sample. The syngas flowing out from the main reaction chamber is sub-divided into two paths; one passes to the sampling line while the other is passed through the exhaust system.

Fig. 1. A photograph of the experimental facility.

The bypass line has a non-return valve and a flow meter to assure the desired unidirectional flow out from the reactor. The syngas sample is then introduced to a condenser followed by a low pressure filter and a moister absorber (anhydrous calcium sulfate). This procedure assured that the sample is dry prior to its introduction into a gas analyzer. The filtered and dried syngas is then analyzed using a GC or a mass spectrometer.

[The description of the experiment is omitted]

4. Results and discussion

The characteristic of syngas from food waste pyrolysis and gasification have been investigated. Food waste is a char-based sample. Results from char-based samples (samples containing volatile matter and char, such as paper [13], cardboard [14,15], woodchips and food waste) follow, qualitatively similar trend. Syngas is characterized by a high flow rate initially, due to pyrolysis, and then followed by a small flow rate which lasts for longer period, which is due to char gasification.

[Some details are omitted]

5. Conclusions

Gasification yielded enhanced production of syngas, hydrogen and energy as that obtained from pyrolysis. However the time required for gasification is more as compared to pyrolysis. As compared to paper gasification at the same conditions, food waste needed more time to complete the gasification process. Inorganic constituents in food char were found to have a catalytic effect. Char reactivity increased with degree of conversion. In the conversion range from 0.1 to 0.9 the increase in reactivity was accompanied by an increase in pre-exponential factor, suggesting an increase in gasifying agent adsorption rate to char surface. However, in the conversion range from 0.93 to 0.98 the increase in reactivity was accompanied by a decrease in activation energy. A compensation effect was observed in this range of conversion, from 0.93 to 0.98. Isokinetic temperature obtained from Arrhenius plots for X from 0.93 to 0.98 was 1001 oC.

Acknowledgment

This research was supported by the ONR and is support is gratefully acknowledged.

References

[1] <http://www.landfill-gas.com>.

[2] Tancredi N, Cordero T, Mirasol JR, Juan J. CO2 gasification of eucalyptus wood chars. Fuel 1996;75(13):1505–8.

[3] Montesinos FM, Cordero T, Mirasol JR, Rodriguez JJ. CO2 and steam gasification of a grapefruit skin char. Fuel 2002;81:423–9.

[4] Marsh H, Taylor DA, Lander JR. Kinetic study of gasification by oxygen and carbon dioxide of pure and doped graphitizable carbons of increasing heat treatment temperatures. Carbon 1981;19(5):375–81.

[5] Agrawal RK. On the compensation effect. J Therm Anal 1986;31:73–86.

[6] Dhupe AP, Gokarn AN, Doraiswamy LK. Investigations into the compensation effect at catalytic gasification of active charcoal by carbon dioxide. Fuel 1991;70(7):839–44.

[7] Feistel PP, Van Heek KH, Juntgen H, Pulsifer AH. The compensation effect in the steam gasification of coal. Carbon 1976;14(6):363–4.

[8] Gokarn AN, Muhlen HJ. Catalysis of char gasification by mixed lignosulfonates: quantification of role of each component. Fuel 1996;75(1):96–8.

[9] Li S, Cheng Y. Catalytic gasification of gas–coal char in CO2. Fuel 1995;74(3):456–8.

[10] Meher LC, Sagar DV, Naik SN. Technical aspects of biodiesel production by transesterification-a review. Renew Sust Energy Rev 2006;10:248–68.

[References 11-16 are omitted]

BioMedical Engineering OnLine 2010, 9:84 (http://www.biomedical-engineering-online.com)