FRAME 15-17

Seat Covers

Seat Cover Removal

•Remove:

Seats (see Front/Rear Seat Removal) Bolts [A]

•Pull the front seat cover [B] backward to clear the hook portions [C], and remove it upward.

•Remove the quick rivets [A].

○Push the central pin, and then remove the quick rivet.

•Remove the quick rivets [A] and bolts [B].

•Pull the seat covers [C] evenly outward to clear the hook portions [D], and remove them.

•Disconnect the connectors [A].

•Remove: Bolts [A]

Flap (with Turn Signal and License Plate Lights)

15-18 FRAME

Seat Covers

•Remove the bolt [A].

•Clear the hook portion [B] from the slot.

•Remove the lower end [A] of the seat lock cable [B].

•Remove: Connector [A] Bolt [B]

Rear Seat Cover [C]

Tail/Brake Light (LED) (see Tail/Brake Light (LED) Removal/Installation in the Electrical System chapter)

Seat Cover Installation

•Installation is the reverse of removal, note the following. ○Run the harness, cables and leads correctly (see Cable, Wire, and Hose Routing section in the Appendix chapter). ○Apply a non-permanent locking agent to the threads of

the flap mounting bolts.

○Insert the hook portion [A] into the slot [B].

FRAME 15-19

Seat Covers

○Insert the hook portions [A] into the slots [B].

○Check that the pad [A] is in place on the front seat cover [B].

○Insert the hook portions [A] into the slots [B].

Upper Seat Cover Removal (Only on Ninja ZX-6R

MONSTER ENERGY® Model)

•Insert the ignition switch key [A] into the seat lock.

•Pull up the upper seat cover [B] upward while turning the key clockwise, and remove it forward.

Upper Seat Cover Installation (Only on Ninja ZX-6R MONSTER ENERGY® Model)

•Slip the upper seat cover hook [A] under the rib [B] on the rear frame rear.

•Insert the latches [C] into the latch holes [D].

•Push down the upper seat cover until the lock clicks.