- •Gold mining
- •Text 1. Some facts from the history of gold mining
- •Diamond Placer
- •Text 3. La paz placers
- •Text 2. Placer mining вy excavating machinery
- •Fig.1. Ruston-Bycyrus dragline excavator
- •Fig. 2. Dragline making first cut
- •Fig.5. General arrangement of property for dragline mining
- •Text 3. Power shovels
- •Cableways
- •Text 4. Excavating equipment in тнe mid 80s
- •Electric mining shovels
- •Hydraulic excavators
- •Fig. 13. Ransomes and Rapier w2000 walking dragline stripping overburden at phosphate mine in Jordan
- •Fig. 14. Shows the rh120c introduced in 1933 as an intermediate size between the rh75 and rh300, incorporating “Tripower" geometry
- •Text 2. Dredging in the north
- •Stripping
- •Dredging
- •Vocabulary
- •Text 3. Thawing
- •Other operating problems
- •Nodules
- •20° Angle Gave Best Results
- •Fig. 17. Nodule dredge configuration shown was chosen after a series of increasingly complex dredge designs
- •Larger Dredge Lines Cause Problems
- •Dredge Vessel Specifications
- •Ship Positioning By Dead Reckoning
- •10 Tpd Average
- •Fig. 18. Stages in mining diamondiferous gravel
- •Transport
- •Milling
- •Effects
- •What is Cyanide?
- •Prevention/Solution
- •Text 2. Sluicing
- •Sluice Boxes
- •Water Required
- •Tailings
- •Text 3. Excavation and treatment of gravel
- •Fig. 29. Sluicing by direct loading method
- •Fig. 30. Method of working with ample water supply and steep valley
- •Text.2 working of terrace and alluvial deposits
- •Fig. 33. Method of working river terrace and eluvial deposits
- •Fig. 34. Example of exploitation plan
- •Text 2. Hydraulic mining
- •Fig. 35. Sketch of giant or monitor
- •Text 3. Hydraulic elevators
- •Fig. 41. Hendy hydraulic gravel elevator
- •Fig. 42. Section of elevator pit (Joshua Hendy Iron Works)
- •Text 4. Sluice boxes for hydraulicking
- •Text 2. Miscellaneous methods of mining
- •Text 3. Khetri copper complex
- •Text 4. Kherti and kolihan mines
- •Fig. 46. Longituainal section of Kherti mine, showing principal shafts, main levels and stoping areas
- •In Kolihan mine, small footwall ore-shoots are worked by a sub-level top-slicing method using jackhammers and remote controlled Cavo loaders.
- •Shafts at the Kherti and Kolihan mines
- •Fig. 48. The service shaft, Khetri mine
- •Central services
- •Personnel and housing
Vocabulary
a pipe – труба
to be spaced – быть размещенным
triangle – треугольник
to emerge –появляться, выступать
to percolate – просачиваться, дренировать
point –точка
absorption –впитывание, просачивание
run-off – сток
wear –износ
tear – рвать, царапать, изнашивать
marginal – краевой, боковой, окраинный
clog –засорять, закупоривать
a settking pond –отстойник
frost –мерзлота
Exercise 14. Find the meaning of the word combinations and make up sentences with five of them:
to remove overlying muck; to thaw the material; to pump water; regularly spaced pipes; to go to bedrock; to emerge to bedrock; to percolate up through the gravel; three-month period; water supply; to clog the thawing points; thawing points; problems of improperly thawed ground; loss of gold.
READING
Exercise 15. Read the text looking for the main ideas concerning thawing
Text 3. Thawing
Stripping in any one area is continued to a point where as much as possible of the overlying muck has been removed and the top of the underlying gravel exposed. It is rarely possible to remove all the muck and what remains on the ground has to be thawed. The process of thawing is radically different from that of stripping. Since the material cannot be washed away, it must be thawed in place and for that purpose water must be introduced to its full depth. In the thawing operations, water is pumped into the gravel through a series of regularly spaced pipes, of1/3 and 3/4 in.dia, at а pressure of about 20 lb.per sq.in. Standard spacing for thawing calls for a pipe (or "point") to be driven into the gravel at each corner of regularly spaced equilateral triangles with sides from 16 ft. to 24 ft. in length. Points so spaced are driven to bedrock. If the ground is difficult it is sometimes the practice to drive intermediate points or "sweaters" in the centre of each of the triangles. Such "sweaters” do not usually go to bedrock. The standard spacing points are varied in special cases where considerable depth of muck has to be thawed and they may sometimes be as little as 4ft.apart.
The water from a thawing point emerges at bedrock, and percolates slowly around the bottom of the point and up through the adjoining gravel. It has been found by experience that a period of from one to three months continued operation of a set of points will sufficiently thaw the gravels. Much depends, оt course, on the temperature of the water, the spacing of the points, the depth and nature of the gravel and the extent to which the ground has been previously worked. Old workings, in fact, constitute a special problem of their own. Thawing in such ground is often more of an art than a science and demands, for success, foremen who have themselves had experience in the old time methods of mining and who are competent to form a mental picture of the underlying ground.
It is the usual custom to speak of a thawing "unit" of 400 to points, and a given dredge operation will require 5 or 6 such units or more of ground has to be gained on the dredge. It is most desirable to have sufficient equipment not only to keep thawing operations well ahead of the dredge but to gain progressively until two years or more of ground thawed in advance is always available. While ground can be sufficiently thawed in a short period of dredging there is a distant advantage in letting it lie "fallow" for some months after thawing points have been withdrawn. When this is done small remaining "pillars" of frost tend to thaw out owing to the absorption of heat from surrounding thawed material.
Where once local water is available and stripping and thawing operations have to be carried on in the same area at the same time there is a problem in the handling of water supply. Water that has been used for stripping cannot be taken up in the run-off and used for thawing without hopelessly clogging the thawing points and the gravel itself. Such stripping run-off water must be by-passed the thawing area. Where water for thawing is scanty it can 11 necessary be re-circulated and used again and again in the thawing operations. In such cases, the run-off from the thawing points is allowed to collect in a large settling pond from which it is pumped back into the thawing points.
The successful preparation of frozen ground is the important single problem in the company's business. Могe money can be lost in trying to dig improperly thawed ground that in any other way - loss in excessive wear and tear on the bucket line and machinery, in loss of yardage, and in actual loss of gold in unwashed and frozen lumps of gravel carried through the dredge into the tailings. Completely frozen gravel is as impossible to dig as granite. While this is true, it is also true that there is a nice point of decision as to the stage at which gravel becomes sufficiently thawed to be dredged. All dredges must dig some frost and, in practice on arrives at a marginal point for most economical digging which is somewhere short of a theoretically perfect "thaw", but none the less, is sufficient to protect the buckets, etc, against undue wear and tear, and loss of gold.
There have been many theories as to the thawing power of the sun's rays on gravel which had been stripped of its overlying blanket of muck. The company has dredged a number of areas which had been stripped in the early days but where, as the gravel was relatively shallow, no thawing had been done.
It has been found in such, cases that erratic thawing will occur naturally to a depth of, perhaps, 8 to 10 it. or more, but this cannot the depended upon and, in practice, some artificial thawing is nearly always require. In the early days of the Klondike all thawing was done with stream, at a cost of from 25 to 40 cents or more per cu. yd. dredged. The discovery that frozen gravel could be thawed with water at natural temperatures has cut this cost to little more than four cents per cu. yd. The temperature of the water used for thawing today rarely exceeds 55 P. even in the middle of summer.
