Добавил:
Upload Опубликованный материал нарушает ваши авторские права? Сообщите нам.
Вуз: Предмет: Файл:
Petroleum Refining.doc
Скачиваний:
3
Добавлен:
01.07.2025
Размер:
2 Мб
Скачать
☆
  1. Переведите текст.

An oil refinery is an industrial process plant where petroleum crude oil converts into high-octane motor fuel, diesel oil, liquified petroleum gases, jet aircraft fuel, kerosene, heating fuel oils, lubricating oils, asphalt and petroleum coke. Common process units which found their application in a refinery are:

  • Desalter unit washes out salt from the crude oil before it enters the atmospheric distillation unit.

  • Atmospheric distillation unit distills crude oil into fractions.

  • Vacuum distillation unit further distills bottom residuals after atmospheric distillation.

  • Naphtha hydrotreater unit uses hydrogen to desulfurize naphtha from atmospheric distillation.

  • Catalytic reformer unit is used to convert the naphtha-boiling range molecules into higher octane reformate.

  • Distillate hydrotreater unit desulfurizes distillates after atmospheric distillation.

  • Fluid catalytic cracking unit upgrades heavier fractions into lighter, more valuable products.

  • Hydrocracker unit uses hydrogen to upgrade heavier fractions into lighter, more valuable products.

  • Visbreaking unit upgrades heavy residual oils by thermally cracking them into lighter, more valuable reduced viscosity products.

  • MEROX unit treats LPG, kerosene or jet fuel by oxidizing mercaptans to organic disulfides.

  • Coking units process very heavy residual oils into gasoline and diesel fuel, leaving petroleum coke as a residual product.

  • Alkylation unit produces high-octane component for gasoline blending.

  • Dimerization unit converts olefins into higher-octane gasoline blending components.

  • Isomerization unit converts linear molecules to higher-octane branched molecules for blending into gasoline or feed to alkylation units.

  • Steam reforming unit produces hydrogen for the hydrotreaters or hydrocrackers.

  • Liquified gas storage units for propane and similar gaseous fuels use the pressure sufficient to maintain gases in liquid form.

  • Storage tanks are used for crude oil and finished products.

  • Amine gas treater, Claus unit, and tail gas treatment are intended for converting hydrogen sulfide from hydrodesulfurization into elemental sulfur.

  • Utility units such as cooling towers for circulating cooling water, boiler plants for steam generation, instrument air systems are used for pneumatically operated control valves and an electrical substation.

  • Wastewater collection and treating systems consisting of API separators, dissolved air flotation units and some type of further treatment make discharge water suitable for reuse or disposal.

  • Solvent refining units use solvent such as cresol or furfural to remove unwanted, mainly asphaltenic materials from lubricating oil stock.

  • Solvent dewaxing units remove the heavy waxy constituents petrolatum from vacuum distillation products.

The process flow diagram below is an example of a schematic or block flow diagram and depicts the various unit processes within a typical oil refinery.

A process flow diagram is a diagram commonly used in chemical and process engineering to indicate the general flow of plant processes and equipment. The flow diagram displays the relationship between major equipment of a plant facility and does not show minor details such as piping details and designations. Another commonly-used term for a process flow diagram is a flow sheet.

Fig. 11.1. Oil Refinery Flow Sheet

Соседние файлы в предмете [НЕСОРТИРОВАННОЕ]