IV. Reverb

• Spring Reverb (Either one) - Most lush-sounding reverb in the Pod, but a high DSP price.

• Hall Reverb - This is my go-to. Great tone and natural decay. It's also mono wet, stereo dry, so you get stereo bleed via the effect, which I find sounds nice, but may be a dealbreaker if you're running dual outputs.

• Room Reverb - Similar to the Hall Reverb but not quite as nice and its hard to get the decay to sound completely natural. True stereo effect, though.

• Plate Reverb - Pretty good and basic reverb sound. Maybe less expensive DSP-wise than Room Reverb?

Top of Effects

V. Delay

• Digital Delay - I like my delay to sound simply like delay. Here it is in full transparency. However, to make it sound more like a real echo, turn the treble down a hair.

• Digital Delay w/ Mod - If I can't fit a Mod effect due to DSP constraints or I want a very subtle mod in the tone, I like this effect.

• Echo Platter Dry - This is what I use if I want to let the delay shape the tone a little. This effect warms it up a bit.

• Stereo Delay - If I wanna sound 80's.

• Ping Pong Delay - I actually dial this in so there's no ping-pong effect, but I like to use it because it takes up the least DSP, allowing me to squeeze in another effect.

Top of Effects

vi. Pre-EQ

For more on Pre-EQ'ing, see the Amp/Distortion page

• Q Filter - I set this as a band-pass with low Q, medium low Mix, and center the frequency around 56%. Somehow it works better than a Parametric EQ. It's eery how well this works to boost an amp.

• Line 6 Drive - With a Mids parameter that actually sets the center frequency of a mids-boost, this Distortion effect is equipped to be used as a boost. Find the sweet spot for mids, then compensate with bass/treble.

• Screamer - Classic overdrive pedal. Low drive, high output, leave the bass/treble around 50% (don't even exist on the real deal), and slowly increase Tone until you find the sweet spot. I find it's a little scratchier/brighter than the Line 6 Drive, which can sometimes be too much but other times be the extreme sound you want.

• Tube Drive - A bit more vintage than the 2 above options.

• Mid-Focus EQ - Useful to trim bass to dial out the mud or some extreme high end to make the amp less scratchy or splatty. I use this in addition to one of the other offerings on occasion.

• Graphic/Parametric EQ - Either can be used to put a nice hump shape in the frequency response to get that mid-boost you need to get a tight distortion from an amp. The Graphic gives you a bit more ability to shape the low end at the expense of finding a good center frequency.

• Wah Pedals - I don't usually use this approach, but some have found luck using a Wah as a filter to dial in a tighter amp tone. I believe the Pod's wah offerings include a mix parameter, so if you keep that low, you won't sound like you're just using a cocked wah.

B. Dialing in the Flangers

The flangers suck! Or do they?!!? I've tried to dial them in for a while and found a couple paradigms I liked, but only recently truly figured them out.

The quirk is the inclusion of the "Manual" parameter. This control seems designed to be assigned to the expression pedal. Then you can use Width 0% and manually manipulate the "sweep" using the pedal. So you'd think if you don't do that, the setting for "Manual" shouldn't really matter, OH BUT IT DOES! If you set it too low, the sweep seems to bypass the "neutral" position, causing a double-swoosh sound as the sweep hits the extremes. It sounds pretty crappy. So you have to take into account how large you set Width and increase Manual enough to avoid the double-swoosh. But if you go too high, it dilutes the flanging effect. So if you adjust Width, also adjust Manual to find the sweet spot.

The other trick is not to use too large a Width setting. You'd think a higher Width is a bigger sweep sound, but if it's too large, the flanger's comb filter will get into frequencies that are outside the core midrange frequencies that guitar really focus on. This is especially true when running the flanger in front a distorted amp. You hear the swoosh in the middle part of the sweep, but less so on the extremes. I like to keep Width lower and use Manual to center the sweep on the core frequencies where you can really hear it. I like to use the looper to record some simple palm mutes when run before distortion, or some big chords if after. Use settings that get you strong action on that.

High feedback/regen settings can initially sound off-putting and fake, but they really emphasize the flanger sound. I rarely like 100%, but you can't be afraid of it. That said, you don't have to put it high if you want a more subtle effect.

Although some of the flangers include mix settings, they might not actually do anything, so keep that in mind. If you NEED a mix, you'll have to put the flanger in Channel A and use the Mixer to blend it against the "dry" Channel B. You can put your amp behind the mixer.

Top of Effects