Добавил:
Upload Опубликованный материал нарушает ваши авторские права? Сообщите нам.
Вуз: Предмет: Файл:
Honda_CB500_S_93-01_Haynes_Service_Manual_ENG_Skanirovanny.doc
Скачиваний:
7
Добавлен:
01.07.2025
Размер:
12 Мб
Скачать
☆

9.3B ... And the o marks on the camshaft gears (arrowed) align with the cylinder head surface

  1. Mark the front edge of the upper camchain guide to aid reassembly. The four camshaft holders are marked A, B, C and D, with corresponding marks on the inside of the cylinder head (see illustration). These markings ensure that the holders can be matched up to their original locations on installation. If no markings are visible, make your own using a felt pen. Before disturbing the camshaft holders, make a sketch of the layout as a further aid for installation.

  2. Unscrew the camshaft holder bolts for the

camshaft being worked on, evenly and a little at a time in a criss-cross pattern, until they are all loose (see illustration). While slackening the bolts make sure that each holder is lifting squarely away from the cylinder head and is not sticking on its locating dowels. Caution: If the bolts are carelessly loosened and the holder does not come squarely away from the head, the holder is likely to break. If this happens the complete cylinder head assembly must be renewed as the holders are matched to the cylinder head and cannot be renewed separately. Also, a camshaft could be damaged if the holder bolts are not slackened evenly and the pressure from a depressed valve causes the shaft to bend. Remove the bolts, noting their positions, and the upper camchain guide, then lift off the camshaft holders. Retrieve the dowels from either the holder or the cylinder head if they are loose (see illustration). Disengage each camshaft sprocket from the camchain and lift each camshaft out of the head. The camshafts are marked for identification. The inlet camshaft is marked 'IN' and the exhaust camshaft is marked 'EX' (see illustration).

9.5 Marks on camshaft holders correspond with marks on cylinder head

9.6a Unscrew the camshaft holder bolts evenly

9.6b Retrieve the dowels (arrowed) for safekeeping

9.6c Note the camshaft identification marks

Engine, clutch and transmission 2»13

9.7 Check the journal surfaces of the camshaft for scratches or wear

Secure the camchain with a length of wire to prevent it dropping into the crankcase.

Inspection

7 Inspect the bearing surfaces of the camshaft holders and the corresponding journals on the camshaft. Look for score marks, deep scratches and evidence of spalling (a pitted appearance) (see illustration).

8 Check the camshaft lobes for heat discoloration (blue appearance) score marks, chipped areas, flat spots and spalling (see illustration). Measure the height of each lobe with a micrometer (see illustration) and compare the results to the minimum lobe height listed in this Chapter's Specifications. If damage is noted or wear is excessive, the camshaft must be renewed. Also check the condition of the cam followers in the cylinder head (see Section 12).

9 Check the amount of camshaft runout by supporting each end of the camshaft on V-blocks, and measuring any runout at the journals using a dial gauge. If the runout exceeds the specified limit the camshaft must be renewed.

hint

Refer to Tools and Workshop Tips in the Reference section for details of how to read a micrometer and dial gauge.

10 The camshaft bearing oil clearance should now be checked. There are two possible ways

Соседние файлы в предмете [НЕСОРТИРОВАННОЕ]