Добавил:
Upload Опубликованный материал нарушает ваши авторские права? Сообщите нам.
Вуз: Предмет: Файл:
Honda_CB500_S_93-01_Haynes_Service_Manual_ENG_Skanirovanny.doc
Скачиваний:
7
Добавлен:
01.07.2025
Размер:
12 Мб
Скачать
☆

7.7 Remove the damper rod bolt and sealing washer (arrowed)

6

6*8 Frame, suspension and final drive

7.9 Prise out the dust seal...

9 Carefully prise out the dust seal from the top of the slider to gain access to the oil seal retaining clip (see illustration). Discard the dust seal as a new one must be used.

  1. Carefully remove the retaining clip, taking care not to scratch the surface of the tube (see illustration).

  2. To separate the tube from the slider it is necessary to displace the top bush and oil seal. The bottom bush will not pass through the top bush, and this can be used to good effect. Push the tube gently inwards until it stops against the damper rod seat. Take care not to do this forcibly or the seat may be damaged. Then pull the tube sharply outwards until the bottom bush strikes the top bush. Repeat this operation until the top bush and seal are tapped out of the slider (see illustration).

7.12 Oil seal (a), washer (b), top bush (c) and bottom bush (d)

7.10 ... Then carefully remove the oil seal retaining clip

  1. With the tube removed, slide off the oil seal and its washer, noting which way up they fit (see illustration). Discard the oil seal as a new one must be used. The top bush can then be slid off the upper end of the tube. Caution: Do not remove the bottom bush from the tube unless it is to be renewed.

  2. Tip the damper rod seat out of the slider, noting which way up it fits.

Inspection

7.15 Checking the fork tube runout with V-blocks and a dial gauge

14 Clean all parts in solvent and blow them dry with compressed air, If available. Check the fork tube for score marks, scratches. flaking of the chrome finish and excessive or abnormal wear. Look for dents in the tube and renew the tube in both forks if any are found. Check the fork seal seat for nicks, gouges and scratches. If damage is evident, leaks will

7.11 Pull the fork tube and slider apart to drive the top bush out

occur. Also check the oil seal washer for damage or distortion and renew it if necessary.

15 Check the fork tube for runout using V-blocks and a dial gauge, or have it done by a Honda dealer (see illustration). If the amount of runout exceeds the service limit specified, the tube should be renewed.

A Warning: If the tube is bent or exceeds the runout limit, it should not be straightened; renew it.

  1. Check the spring for cracks and other damage. Measure the spring free length and compare it to the specifications at the beginning of this Chapter. If it is defective or has sagged below the service limit, renew the springs in both forks. Never renew only one spring. Also check the rebound spring.

  2. Examine the working surfaces of the two bushes; if worn or scuffed they must be renewed. To remove the bottom bush from the fork tube, prise it apart at the slit using a flat-bladed screwdriver and slide it off (see illustration). Make sure the new one seats properly.

  3. Check the damper rod and its piston ring for damage and wear, and renew them if necessary (see illustration). Do not remove the ring from the piston unless it requires renewal

Reassembly

19 If removed, install the new piston ring into the groove in the damper rod, then slide the rebound spring onto the rod (see illustration).

Соседние файлы в предмете [НЕСОРТИРОВАННОЕ]