Добавил:
Upload Опубликованный материал нарушает ваши авторские права? Сообщите нам.
Вуз: Предмет: Файл:
Honda_CB500_S_93-01_Haynes_Service_Manual_ENG_Skanirovanny.doc
Скачиваний:
7
Добавлен:
01.07.2025
Размер:
12 Мб
Скачать
☆

19.4B Gearchange shaft thrust washer (arrowed)


1 Make sure the transmission is in neutral. Remove the clutch (see Section 15). There is no need to remove the oil pump drive chain and sprockets.

  1. Unscrew the gearchange lever pinch bolt and remove the lever from the shaft, noting the alignment punchmark (see illustration). If no mark is visible, make your own before removing the lever so that it can be correctly aligned with the shaft on installation.

  2. Wrap some insulating tape around the gearchange shaft splines to avoid damaging the oil seal as it is removed.

  3. On the right-hand side of the engine, note how the gearchange shaft return spring ends fit on each side of the locating pin in the casing, and how the shaft selector arm pawls engage with the pins on the selector cam (see illustration). Withdraw the gearchange shaft and its thrust washer from the casing (see illustration).

  4. Note where the ends of the gearchange stopper arm return spring locate and how the roller on the arm rests in the neutral detent on the selector cam (see illustration). Unscrew the bolt securing the stopper arm and withdraw the arm, thrust washer and spring from the casing (see illustration).

Inspection

6 Inspect the stopper arm return spring and the gearchange shaft return spring. If they are fatigued, worn or damaged they must be renewed. The shaft return spring is retained

19.5a Ends of the stopper arm return spring (A) and neutral detent on cam (B)

19.5b Remove the gearchange stopper 19.5c ... and inspect the return spring (A), arm assembly ... thrust washer (B), arm (C) and bolt (D)

Engine, clutch and transmission 2»33

19.6 Gearchange shaft circlip (A), circlip groove (B) and pawl mechanism (C)

19.8a Prise the old oil seal out with a flat-bladed screwdriver...

19.8b .. . press the new seal in with a suitably sized socket

by a circlip. To remove the circlip, slide it down the length of the shaft, do not stretch it over the shaft (see illustration).

  1. Also check that the shaft return spring locating pin in the casing is securely tightened. If it is loose, remove it and apply a suitable non-permanent thread-locking compound, then tighten it to the torque specified at the beginning of this Chapter.

  2. Check the gearchange shaft for straightness and damage to the splines. If the shaft is bent you can attempt to straighten it, but if the splines are damaged the shaft must be renewed. Also check the condition of the shaft oil seal in the casing and renew it if damaged or deteriorated. Lever the old seal out using a flat-bladed screwdriver and press the new seal in squarely with a suitably sized socket (see illustrations).

  3. Inspect the gearchange shaft selector arm for wear where it bears on the return spring. Also inspect the selector arm pawl mechanism and spring for wear or damage (see illustration 19.6). The gearchange shaft and selector arm mechanism must be renewed as one assembly.

  1. Check for wear on the selector cam pins and cam lobes, and the stopper arm and the stopper arm roller. If they are worn or damaged they must be renewed.

  2. Remove the gearchange cam by unscrewing the bolt in its centre. A recess in the back of the cam locates on a pin in the end of the selector drum. Remove the pin for safekeeping (see illustration).

Соседние файлы в предмете [НЕСОРТИРОВАННОЕ]