Добавил:
Upload Опубликованный материал нарушает ваши авторские права? Сообщите нам.
Вуз: Предмет: Файл:
Honda_CB500_S_93-01_Haynes_Service_Manual_ENG_Skanirovanny.doc
Скачиваний:
7
Добавлен:
01.07.2025
Размер:
12 Мб
Скачать
☆

9.8A Check the lobes of the camshaft for wear - here's an example of damage requiring repair or renewal

of doing this, either by direct measurement (see Steps 11 to 13) or by the use of a product known as Plastigauge (see Steps 14 to 19).

  1. If the direct measurement method is to be used, make sure the camshaft holder dowels are in position then fit the holders, making sure they are in their correct location (see Step 5). Tighten the holder bolts evenly and a little at a time in a criss-cross pattern to the torque setting specified at the beginning of the Chapter. Using telescoping gauges and a micrometer (see Tools and Workshop Tips), measure the diameter of the journal holders. Now measure the diameter of the corresponding camshaft journals with a micrometer (see illustration). To determine the journal oil clearance, subtract the journal diameter from the holder diameter and compare the result to the clearance specified. If any clearance is greater than specified, it is an indication of wear on the camshaft, the holder, or both.

  2. First check to see if the camshaft journals are worn below the service limit. If they are, a new camshaft must be fitted. However, since it is likely that the holder is also worn, ensure that the specified journal diameter for a new camshaft will restore the oil clearance to within specification before buying a new camshaft.

  3. If the camshaft journals are good, or if fitting a new camshaft will not restore the oil clearance to within specification, the holders and cylinder head will have to be renewed.

9.8B Measure the height of the camshaft lobes with a micrometer

  1. If the Plastigauge method is to be used, clean the camshafts, the bearing surfaces in the cylinder head and camsh.afl holders with a clean lint-free cloth, then lay the camshafts in place in the cylinder head.

  2. Cut strips of Plastigauge and lay one piece on each bearing journal, parallel with the camshaft centreline (see illustration). Make sure the camshaft holder dowels are in position then fit the holders, making sure they are in their correct location (see Step 5). Tighten the holder bolts evenly and a little at a time in a criss-cross pattern to the torque setting specified at the beginning of the Chapter. While doing this, don't let the camshafts rotate.

  3. Now unscrew the bolts evenly and a little at a time in a criss-cross pattern, and carefully lift off the camshaft holders.

  4. To determine the oil clearance, compare the crushed Plastigauge (at its widest point) on each journal to the scale printed on the Plastigauge container (see illustration). Compare the results to this Chapter's Specifications. Carefully clean away all traces of the Plastigauge using a fingernail or other object which will not score the bearing surfaces.

  5. If any clearance Is greater than specified, it is an indication of wear on the camshaft, the holder, or both. First check to see if the camshaft journals are worn below the service limit. If they are, a new camshaft must be

Соседние файлы в предмете [НЕСОРТИРОВАННОЕ]