Jumper Blocks |
Intel® Server Boards S5000PSL and S5000XSL TPS |
6.Jumper Blocks
The server board has several 3-pin jumper blocks that can be used to configure, protect, or recover specific features of the server board.
Pin 1 on each jumper block can be identified by the following symbol on the silkscreen: ▼
BIOS Bank Select
Force Lower
Bank
2
Normal
Operation 3 (default)
J1C3
CMOS Clear
Disable
2
Enable
3
J1D1
Password Clear
Protect
2
Clear
3
J1D2
BMC Force Update
Disable
2
Enable
3
J1E3
AF000422
Figure 17. Jumper Blocks (J1C3, J1D1, J1D2, J1E32)
Table 39. Server Board Jumpers (J1C3, J1D1, J1D2, J1E3)
Jumper Name |
Pins |
System Results |
|
|
|
|
|
J1C3: BIOS Bank |
1-2 |
If these pins are jumpered, the system will boot from an alternate BIOS image. |
|
Select |
|
|
|
2-3 |
System is configured for normal operation. (Default) |
||
|
|||
|
|
|
|
J1D1: CMOS |
1-2 |
These pins should have a jumper in place for normal system operation. (Default) |
|
Clear |
|
|
|
2-3 |
If these pins are jumpered, the CMOS settings will be cleared 5 seconds after removing |
||
|
|||
|
|
AC power. These pins should not be jumpered for normal operation. |
|
|
|
|
|
J1D2: Password |
1-2 |
These pins should have a jumper in place for normal system operation. (Default) |
|
Clear |
|
|
|
2-3 |
If these pins are jumpered, administrator and user passwords will be cleared 5 seconds |
||
|
|||
|
|
after removing AC power. These pins should not be jumpered for normal operation. |
|
|
|
|
|
J1E3: BMC |
1-2 |
BMC Firmware Force Update Mode – Disabled (Default) |
|
Forced Update |
|
|
|
2-3 |
BMC Firmware Force Update Mode – Enabled |
||
|
|||
|
|
|
48 |
Revision 1.7 |
|
|
|
Intel order number: D41763-008 |